Chain crusher is one of the important equipment for the production of organic fertilizer, and its debugging step is very important for the normal operation and service life of organic fertilizer equipment. The following are the commissioning steps of the chain mill:

1. Check whether the components of the device are complete, secured, or damaged.

2. Check whether the bearing grease is sufficient and whether it needs to be replaced.

3. Adjust the tightness of the sprocket chain to make it in the best condition.

4. Open the feed port to check whether the material enters the crushing chamber smoothly. If there is blockage, adjust the feed speed or clean up the blockage.

5. Adjust the discharge port of the crushing chamber so that it is well matched with the sprocket chain to ensure that the material can be smoothly discharged.

6. Adjust the position of the hammer, so that the hammer can evenly impact the material, to avoid the hammer skew or collision with the shell.

7. Test run the equipment, observe whether the components have abnormal sound or vibration, if abnormal, adjust or replace the parts in time.

8. Adjust the speed and power of the motor so that the equipment can achieve the best crushing effect.

9. In the production process of organic fertilizer production line, regularly check the wear of the equipment and replace the wear parts in time.

The above is the commissioning steps of the chain mill, through the correct commissioning and maintenance, you can ensure the normal operation and service life of the equipment, improve production efficiency and product quality.