Your current location: Home > Industry Info
PRODUCTS List+
Industry Info

Organic fertilizer use flat die granulator and main features

2019-07-02
Multi-functional flat die granulator can produce pellet feed, organic fertilizer, and the produced pellets are cylindrical. It can also be connected with polishing equipment to make cylindrical pellets roll into balls at once, without returning pellets, with high granulation rate and good strength. Beautifully mobilized, it is the ideal equipment for the production of organic fertilizer and pellets for feed production. The flat film granulator is used for granulating various organic substances after fermentation, breaking through the conventional organic granulation process. It is not necessary to dry and pulverize the raw materials before granulation, and the cylindrical granules can be processed by direct batching, which can save a lot of energy.


Flat die granulator features:
1. The pressure roller is used, and the two ends are consistent with the linear velocity of the inner and outer rings of the die plate. The misalignment friction between the wheel and the die does not occur, the resistance is reduced, the kinetic energy loss is reduced, the service life of the die is prolonged, and the production cost is reduced.
2. The pressure roller is evenly arranged, the operation is stable, and the pressing area is increased, which improves the production efficiency.
3. Adopting screw center pressure regulating structure, the gap of the mold can be large or small, suitable for different materials to ensure the pressing effect.
4. This model is equipped with Φ1.5-Φ20mm multi-aperture molds, which can adapt to different materials granulation and achieve better benefits.
5. The produced pellets are cylindrical.
6. High organic fertilizer content, achieving pure organic granulation.
7. The use of organic particles can be inlaid with each other under the action of the action, and no binder is needed for granulation.
8. The particles are firm and can be sieved after granulation to reduce the drying energy consumption.
9. The organic matter after fermentation does not need to be dried, and the moisture content of the raw materials can be 20%-40%.

Note on the use of flat die extrusion granulator:
1. When using it, it should be noted that there should be no hard objects such as stones and iron blocks in the raw materials. After the roller is working for more than ten shifts (8 hours for one shift), it is necessary to apply the high-temperature grease on the bearing to make the roller work well and extend the bearing life.
2. During the granulation, it is strictly forbidden to contact the embossing roller and the template.
3. If the particles are broken or not pressed properly, the crude fiber material formula should be reduced to less than 50%.
4. When granulation, no granulation or no discharge occurs, the template should be removed, and after the hole is open, some fiber materials can be added to restart granulation.
5. The tightness of the belt should be checked frequently, and the gearbox leaks oil and the oil seal is replaced in time.


Products
Tel
contact
inquiry